Wood Replica Coffin
1 Paint the outside of the Casket Prices and lid with gray flat wall paint using a 2 1/2-inch paint brush. Let dry.
2 Draw horizontal lines that are 3 inches apart across the gray painted surface using a black paint pen or permanent marker.
3 Start on one end of the coffin and draw a perpendicular line between two of the horizontal lines. Measure down 1 1/2 feet and draw another perpendicular line. Continue adding lines until you reach the opposite end of the coffin.
4 Start drawing lines across the set of horizontal lines next to the first set but stagger the first horizontal line so it is about 2 inches off and not perfectly even. Continue until you have converted all of your horizontal stripes into wood boards.
5 Draw two small circles with the black paint pen or marker along each side of the shorter lines going across the coffin to indicate the nails that hold the coffin in place.
6 Spray the outside of the Wholesale Coffins sparingly around the seams with stone-colored textured spray paint to give it an aged look, if desired.
Vampire Lair
7 Paint the entire coffin, inside and out, with black flat wall paint using a 2 1/2-inch wide paint brush. Let dry.
8 Remove the coffin lid. Place 3 yards of red satin fabric along the inside of the coffin. Smooth the fabric down so it fits along the sides and bottom. Fold any excess fabric over the edges of the coffin. Trim the fabric so it is flush with each of the edges.
9 Staple the fabric using a staple gun around the inside edges of the coffin. Wrinkle the fabric occasionally as you staple to add detail to the liner, but do not wrinkle it so much that the material draws up and is too short to go around the entire coffin.
10 Use hot glue to attach 2-inch-wide black satin ribbon along the inside edge of the coffin to cover up the staples you used for the red satin liner.
11 Spray Christmas snow lightly along the top of the rim of the coffin. Spray the snow across the inside of the lid to add a dusty appearance; when the coffin lid is removed, some of the snow that is not stuck to the lid will blow out adding to the effect.
12 Stretch fake white cobwebs across the inside of the coffin. Make two balls of cobwebs and place these in two of the corners of the satin liner.
If you want to know more,please enter the following link: Vampire Coffin .
